AIRLESSCO 910E Manuel d'instructions télécharger pdf (Page 8)

SETTING UP

FIG. 5

1. CONNECT THE HOSE AND GUN

2. FILL THE PACKING NUT/WET CUP

4. GROUNDING

a. Remove the plastic cap plug from the outlet and screw a

conductive or grounded 3000 psi spray hose onto

uid outlet.

b. Connect an airless spray gun to the other end of the

hose, but do not install the spray tip yet!

NOTE: Do not use thread sealer on swivel unions as they

are made to self seal.

Fill the Packing Nut/Wet

Cup with 5 drops of

Airlessco Throat Seal

Oil (TSO).

Be sure the electrical service is 120 VAC, 15 amp

minimum, and that the outlet you use is properly grounded.

NOTE: FOR GENERATOR POWER, A MINIMUM

OF 7000 WATT GENERATOR WITH VOLTAGE

REGULATION MUST BE USED.

WARNING: To reduce the risk of static sparking, re or ex-

plosion which can result in serious bodily injury and property

damage, always ground the sprayer and system components

and the object being sprayed, as instructed in the safety warn-

ing section of this manual.

5. FLUSH THE SPRAYER

Follow “Flushing Procedure” on page 5 of this manual.

STARTING UP

PRESSURE CONTROL KNOB is used to

adjust pressure. Turn clockwise (CW) to

increase pressure and counterclockwise

(CCW) to decrease pressure.

1. LEARN THE FUNCTIONS OF THE

CONTROLS.

FIG. 6

PRESSURE CONTROL KNOB:

used to adjust pressure only.

Turn clockwise to increase

pressure and counterclockwise

to decrease pressure.

35 AMP CIRCUIT BREAKER

ON/OFF SWITCH

PRIME/PRESSURE RELIEF VALVE (PRIME/PR VALVE): Used to relieve pressure from

gun/hose/tip and to primethe unit when in OPEN position. (It is in open position when

there is a wider gap between valve handle and cam body). Learn and follow the PRES-

SURE RELIEF PROCEDURE on page 8 of this manual. When in closed position (very

slight gap) the system is pressurized and ready to spray.

When you turn the valve handle and the gap between the valve handle and the cam body

becomes wider - this means the valve is in the open position. It is in the closed position

when the gap becomes very small.

(Prime/PR Valve) Used to relieve pressure

from gun, hose & tip and to primethe unit

when in OPEN position. (It is in open position

when there is a wider gap between valve

handle and cam body.)

When in CLOSED position,there is only a

very slight gapbetween handle & body. When

closed the system ispressurized. Handle as a

loaded rearm!

PRIME/PRESSURE (PR) RELIEF VALVE is used to

prime pump and to relieve pressure from gun, hose and tip.

Prime/Pressure Relief Valve

3. ELECTRICAL SERVICE

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

AIRLESSCO 910E Manuel d'instructions Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Pulvérisateur de peinture AIRLESSCO 910E