AIRLESSCO 3A1182B Manuel d'instructions télécharger pdf (Page 9)

Operation

3A1182B 9

6. Turn the engine ON/OFF switch to ON.

7. Point the gun into the metal pail and hold a metal

part of the gun firmly against the pail. Maintain firm

metal to metal contact between gun and container.

8. Disengage the gun trigger lock and squeeze the

trigger. At the same time, slowly turn the pressure

control knob clockwise, just enough to move liquid

at low pressure.

9. Allow the pump to operate until clean solvent comes

from the gun.

10. Release the trigger and engage the gun trigger lock.

11. If you are going to start spraying, place the pump or

suction tube into the supply container. Release the

gun trigger lock and trigger the gun into another

empty, metal container, holding a metal part of the

gun firmly against the metal pail, forcing the solvent

from the pump and hose. When paint starts coming

from gun, turn pressure control knob to minimum

pressure, place prime/pressure relief valve in prime

(open) position and engage the gun trigger lock.

12. If you are going to store the sprayer, remove the

suction tube or pump from the solvent pail, force the

solvent from the pump and hose. Engage the gun

trigger lock. See Storage, 10.

13. Whenever shutting down the sprayer, follow Pres-

sure Relief Procedure, page 7.

Startup

1. Prepare the material according to the material man-

ufacturer’s recommendations.

2. Place the suction tube into the material container.

3. Start the sprayer.

a. Prime/PR Valve must be “OPEN” in the prim-

ing position.

b. After ensuring the gun trigger lock is engaged,

attach tip and safety guard.

c. Turn the engine ON/OFF switch to the “ON”

position.

d. Turn the Pressure Control Knob clockwise to

prime the pump.

e. After the pump is primed, turn the Prime/PR

Valve to the “CLOSED” position.

f. Turn Pressure Control Knob to the desired

spray pressure.

g. Disengage the gun trigger lock to begin spray-

ing.

NOTICE

To prevent damage and freezing during storage,

never leave water in the fluid pump

ti15989a

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

AIRLESSCO 3A1182B Manuel d'instructions Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Pulvérisateur de peinture AIRLESSCO 3A1182B