AIRLESSCO 24F579 Mustang 5100 Stand Manuel d'instructions télécharger pdf (Page 7)

Operation

3A1185C 7

Operation

Pressure Relief Procedure

1. Engage the gun trigger lock. Refer to the separate

instruction manual provided with gun for safety fea-

tures and how to engage the trigger lock.

2. Turn the unit off.

3. Disengage the gun trigger lock and trigger the gun

to relieve residual fluid pressure.

Hold metal part of the gun in contact with

grounded metal pail. Use minimum pressure.

4. Turn Prime/Pressure Relief Valve (PR Valve) to the

open (priming) position to relieve residual pressure.

There will be a wider gap between valve handle

and cam body when in open position. In the

closed position there is only a very slight gap.

NOTE: The valve handle can move both clockwise and

counter clockwise and can face different directions.

5. Re-engage gun trigger lock and close Prime/Pres-

sure Relief Valve.Turn Prime/Pressure Relief Valve

(PR Valve) to the open (priming) position to relieve

residual pressure.

If the spray tip or hose is clogged, follow Steps 1

through 5 above. Expect paint to splash into the

bucket while relieving pressure during Step 4.

NOTE: If you suspect that pressure hasn’t been relieved

due to damaged Prime/Pressure Relief Valve, or other

reason, slowly loosen the tip nut or hose coupling to

relieve pressure.

Setup

Connect the hose and gun

1. Remove the plastic cap plug from the outlet and

screw a conductive or grounded 3000 psi spray

hose onto fluid outlet.

2. Connect an airless spray gun to the other end of the

hose. Do not install spray tip.

NOTE: Do not use thread sealer on swivel unions as

they are made to self seal.

To reduce risk of injury, follow this pressure relief pro-

cedure whenever you see this symbol throughout this

manual, Also, perform this procedure whenever you:

•Stop spraying

• Check or repair any part of this system

• Install or clean spray nozzle

ti15989a

ti17403a

• To reduce the risk of static sparking, fire or

explosion which can result in serious bodily injury

and property damage. Always ground the sprayer

and system components and the object being

sprayed, as instructed in the safety warning section

of this manual.

• Ensure electrical service is 120 VAC, 15 amp

minimum and the outlet is properly grounded.

• For generator power, a minimum 7000 watt

generator with a voltage regulation must be used.

Closed

(Pressure)

Open

(Priming and Pressure Relief

ti17403a

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

AIRLESSCO 24F579 Mustang 5100 Stand Manuel d'instructions Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Pulvérisateur de peinture AIRLESSCO 24F579 Mustang 5100 Stand